安徽快3

济南震辉保温材料有限公司
地址:章丘工业园
联系人:卢经理
电话:0531-87266820
传真:0531-87266820
邮箱:390062028@qq.com
网址:hbsama.com
当前位置:安徽快3 - 新闻动态
新闻动态
挤塑板在修补孔洞上的应用!
作者:admin 来源:本站 发布时间:2020-10-20 14:31:48 浏览次数:86

  如果挤塑板是被应用在修补孔洞这一方面,那么它的施工处理方式就与平常的施工安装操作是不一样的,所以大家在这一方面一定要多加注意。那么下面小编就来给大家讲讲该板材被应用在修补孔洞这一方面的知识吧。

  If the extruded board is used to repair holes, then its construction treatment method is different from the normal construction and installation operation, so we must pay more attention to this aspect. Then the following small series to tell you about the plate is applied to repair holes in this aspect of knowledge.

  1、在挤塑板施工的时候,应该清理干净混凝土墙面上残留的浮灰、脱模剂油污等杂物,以及抹灰空鼓部位等。

  1. During the construction of extruded plastic board, the residual floating ash, oil stain of release agent and other impurities on the concrete wall surface should be cleaned up, as well as the hollow parts of plastering.

    15948083376963346.jpg

  2、挤塑板应用在修补孔洞中的时候,需要根据孔洞尺寸切割板并打磨其边缘部分,使之能严密封填于孔洞处,并在板两面刷界面剂一道。

  2. When the extruded board is applied to repair holes, it is necessary to cut the plate according to the hole size and grind its edge to make it tightly sealed and filled in the hole, and brush a layer of interface agent on both sides of the board.

  3、等孔洞的水泥砂浆凝固以后,要将挤塑板背面涂10厚的专用粘结剂,将板塞入洞中。

  3. After the cement mortar of the hole is solidified, the back of the extruded plate shall be coated with a special adhesive with a thickness of 10, and the plate shall be inserted into the hole.

  4、而裁剪的面积需要能够覆盖整个修补区域大小的网格布。

  4. The trimmed area needs to be able to cover the entire repair area size of the mesh cloth.

  5、还要涂抹底层聚合物砂浆,埋入修补用的网格布,等到表面不沾手时,再涂面层聚合物砂浆,厚度要和周边一致。

  5. The bottom layer of polymer mortar shall be applied, and the mesh cloth for repair shall be embedded. When the surface does not touch hands, the surface layer polymer mortar shall be applied with the same thickness as the surrounding.

  所以大家在用挤塑板修补孔洞的时候,一定要多加注意以上这些操作事项,避免错误施工而损坏板材的本身性能,耽误施工进度和施工质量。

  Therefore, we should pay more attention to the above operation items when repairing holes with extruded plastic plate, so as to avoid damaging the performance of the plate itself due to wrong construction, and delay the construction progress and construction quality.